Hi
The default IDLE-PC value when adding Cisco IOS 7206VXR (Dynamips) node is "0x62f21000". This works well for the c7200-adventerprisek9-mz.1524-S7 image.
I have installed a new c7200 image called c7200-adventerprisek9-mz.155-2.XB.image. When I change to this new image when adding a node to my topology one of my servers CPU cores goes up to 100% utilization. I have calculated new IDLE-PC value for this image that works. But the problem is that I have to manually change IDLE-PC value each time i add a new 7200 node to my topology. This is because the default value of 0x62f21000 always pops up.
Is it a way to change this default value?
Thanks
Change default IDLE-PC value when adding NODE
Moderator: mike
-
- Posts: 5
- Joined: Fri Nov 10, 2017 11:15 am
-
- Posts: 533
- Joined: Wed Mar 15, 2017 1:54 pm
Re: Change default IDLE-PC value when adding NODE
modify /opt/unetlab/html/templates/c7200.php
E.
E.
-
- Posts: 5
- Joined: Fri Nov 10, 2017 11:15 am
Re: Change default IDLE-PC value when adding NODE
Thanks!
It worked like a charm.
It worked like a charm.
-
- Posts: 7
- Joined: Mon Dec 11, 2017 1:50 pm
Re: Change default IDLE-PC value when adding NODE
Another vote of thanks for this!
Can someone add this step to the "documentation" side of the house at the end of the "idle-pc" section of adding the images?
Can someone add this step to the "documentation" side of the house at the end of the "idle-pc" section of adding the images?