Support and News Forum

The telnet port information USE to be available when you hovered over the device. When I upgraded for 6.2 to 6.4, that little bit of information is no longer available when hovering over the device. Now, I have to click on the device to open a SecureCRT session, go into the properties of that session to determine what the port is. Then go to the correct SecureCRT folder to create a new session with this information. I've been going over the various scripts and methods to get this information through the CLI, none of it works. Please, this shouldn't be a big deal, just provide that information somehow through the GUI.

Thanks,
-Tyler

it was moved to left side bar -- 2nd icon from the top called "Nodes"