Hello all,
I have a question about the Juniper vQFX. I made a script that pulls our infrastructure from librenms and converts it to eve-ng template.
But I seem to have run into an issue that I can only have 10/12 ports. If you do ifconfig on qfx-FE it only goes upto eth9. If you do ifconfig -a there are 52.
Ps. I did have to fix some stuff in eve-ng to connect this many ports to qemu. By adding a pci-bus but even ports on the primary bus are not detected.
Juniper vQFX 12 port limitation?
Moderator: mike
-
- Posts: 1
- Joined: Tue Oct 12, 2021 5:52 am