What images do I need in EVE-NG to do ENCOR and ENSARI?
Moderator: mike
-
- Posts: 1
- Joined: Thu Sep 09, 2021 9:51 am
What images do I need in EVE-NG to do ENCOR and ENSARI?
As the title says. I was able to install EVE on my server with no problem, but these images is a whole other story. I dont know wtf to use for what. Dynamips? IOL? vIOS from VIRL? CML Images? I thought I could rip any IOS out of a Cisco appliance and just use it, but I'm seeing that's not the case. Which images are the best to use? I can't even figure out which ones are for routers and which is for switches. I've looked up countless pages going step by step on stuff but I constantly get errors running commands. I'm just needing resources on this setup that work.https://nox.tips/ https://xender.vip/
Last edited by MaxiBelas on Sun Sep 12, 2021 10:14 am, edited 1 time in total.
-
- Posts: 5084
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: What images do I need in EVE-NG to do ENCOR and ENSARI?
Encor and ENARSI best for Switch and Router are IOL images.
They are IOS 15.X versions and running 98% of all commands you need
As well performance of IOL is 100 times better than vIOS
They are IOS 15.X versions and running 98% of all commands you need
As well performance of IOL is 100 times better than vIOS