What images do I need in EVE-NG to do ENCOR and ENSARI?

Moderator: mike

Post Reply
pndavkota
Posts: 1
Joined: Mon Jan 17, 2022 5:51 am

What images do I need in EVE-NG to do ENCOR and ENSARI?

Post by pndavkota » Mon Jan 17, 2022 8:30 am

As the title says. I was able to install EVE on my server with no problem, but these images is a whole other story. I dont know wtf to use for what. Dynamips? IOL? vIOS from VIRL? CML Images? I thought I could rip any IOS out of a Cisco appliance and just use it, but I'm seeing that's not the case. Which images are the best to use? I can't even figure out which ones are for routers and which is for switches. I've looked up countless pages going step by step on stuff but I constantly get errors running commands. I'm just needing resources on this setup that work 192.168.0.1 router login 192.168.l.l.
Last edited by pndavkota on Thu Jan 20, 2022 3:28 pm, edited 1 time in total.

Uldis (UD)
Posts: 5067
Joined: Wed Mar 15, 2017 4:44 pm
Location: London
Contact:

Re: What images do I need in EVE-NG to do ENCOR and ENSARI?

Post by Uldis (UD) » Mon Jan 17, 2022 5:47 pm

:)
The best are IOL for regular IOS, they wins over vIOS and dynamips because of performance
See below perfrmance test vIOS vs IOL
Also as routers are very good CSR1000v
You do not have the required permissions to view the files attached to this post.

Post Reply